LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1463 (Front Drive Axle) >> Repair Instructions >> Intermediate Shaft Bearing Assembly Replacement - Front Drive Axle (A4WD) >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
    IMPORTANT:
    • Do not nick or cut the inboard (oil pan) inner shaft seal.
    • The intermediate shaft bearing assembly must fit flush against the oil pan in order for the inner axle shaft and the intermediate shaft bearing assembly to be properly installed.
  1. Install the intermediate shaft bearing assembly to the oil pan.
    2. Fig 1: Intermediate Shaft Bearing Assembly Mounting Bolts
    GM761107Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the intermediate shaft bearing assembly mounting bolts.

    Tighten:  Tighten the intermediate shaft bearing assembly bolts to 48 N.m (35 lb ft).

  3. Install the wire harness clip.
  4. Install the right wheel drive shaft. Refer to Wheel Drive Shaft Replacement in Wheel Drive Shafts.
  5. Lower the vehicle.
scientia non olet · About LEMON Manuals