LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1463 (Front Drive Axle) >> Repair Instructions >> Intermediate Shaft Bearing Assembly Oil Seal Replacement >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
  2. Remove the right wheel drive shaft. Refer to Wheel Drive Shaft Replacement in Wheel Drive Shafts.
    3. Fig 1: Removing Outboard, Wheel Drive Shaft Side Inner Shaft Seal
    GM748124Courtesy of GENERAL MOTORS CORP.
  3. Install the J 29369-2  (1) and the J 6125-B  (2) into the outboard, wheel drive shaft side, oil seal as shown. See Special Tools and Equipment .
  4. Remove the outboard, wheel drive shaft side, inner shaft seal by pulling on the J 6125-B  (2). See Special Tools and Equipment .
  5. To replace the inboard, oil pan side side, inner shaft seal, remove the intermediate shaft bearing assembly. Refer to Intermediate Shaft Bearing Assembly Replacement - Front Drive Axle (S4WD)  or Intermediate Shaft Bearing Assembly Replacement - Front Drive Axle (A4WD)  .
  6. Install the intermediate shaft bearing assembly into a vise.

    Place shop towels in the vise in order to protect the intermediate shaft bearing assembly.

    7. Fig 2: Removing Inboard, Oil Pan Side, Seal
    GM756155Courtesy of GENERAL MOTORS CORP.
  7. Install the J 29369-2  (2) and the J 2619-01  (1) into the inboard, oil pan side, oil seal as shown. See Special Tools and Equipment .
  8. Remove the inboard, oil pan side, seal by pulling on the J 2619-01  (1).
scientia non olet · About LEMON Manuals