LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1463 (Front Drive Axle) >> Repair Instructions >> Intermediate Shaft Bearing Assembly Oil Seal Replacement >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the new inboard, oil pan side, inner shaft seal on top of the seal bore.
    2. Fig 1: Installing Inboard, Oil Pan Side, Inner Shaft Seal
    GM781849Courtesy of GENERAL MOTORS CORP.
  2. Install the new seal using the J 45225  (2) and the J 8092  (1). See Special Tools and Equipment .
  3. Install the intermediate shaft bearing assembly. Refer to Intermediate Shaft Bearing Assembly Replacement - Front Drive Axle (S4WD)  or Intermediate Shaft Bearing Assembly Replacement - Front Drive Axle (A4WD)  .
    4. Fig 2: Installing Outboard Intermediate Shaft Bearing Assembly Seal
    GM773845Courtesy of GENERAL MOTORS CORP.
    NOTE: The outboard intermediate shaft bearing assembly seal must be installed 0.9-1.1 mm (0.035-0.043 in) below the surface of the intermediate shaft bearing assembly housing bore. If the seal is not installed properly, damage to the seal may occur.
  4. Install the new oil seal using the J 45359  (2) and the J 8092  (1). See Special Tools and Equipment .
  5. Install the right wheel drive shaft. Refer to Wheel Drive Shaft Replacement in Wheel Drive Shafts.
  6. Lower the vehicle.
scientia non olet · About LEMON Manuals