LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1462 (Vibration Symptoms Diagnosis And Correction) >> Diagnostic Information and Procedures >> Vibration in Service-Stall Test (Torque Sensitive)

Vibration in Service-Stall Test (Torque Sensitive)

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Do not fill the propeller shaft with foam, oil, or any other substance in order to correct a vibration. Filling the propeller shaft is only effective in reducing an unrelated condition called Torsional Rattle. Filling the propeller shaft should only be done in strict adherence to the procedure outlined in corporate bulletins that address Torsional Rattle. Failure to follow the correct procedure will induce a vibration and/or affect the structural integrity of the propeller shaft. The propeller shaft will then have to be replaced.
  1. Support the vehicle on a hoist or jackstands. Support the axle(s) at curb height. Refer to Lifting and Jacking the Vehicle in General Information.
  2. Turn the ignition ON.
  3. Place the transmission in NEUTRAL.
  4. Remove the rear tire/wheel assemblies. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
  5. Remove the brake rotors. Refer to Brake Rotor Replacement - Front or Brake Rotor Replacement - Rear in Disc Brakes.
  6. Hold the J 38792-A  sensor against the pinion nose. See Special Tools and Equipment .
    7. NOTE: Do not depress the brake pedal with the brake rotors and/or the brake drums removed, or with the brake calipers repositioned away from the brake rotors, or damage to the brake system may result.
  7. Start the vehicle.
  8. Place the transmission in the highest forward gear.
  9. Have an assistant accelerate and decelerate the vehicle through the speed range at which the vibration was first noted during the Vibration Analysis - Road Testing procedure.
  10. If a vibration is present, note the J 38792-A  reading during acceleration or deceleration. See Special Tools and Equipment .
  11. Note as to whether or not the pinion nose vibrates under load during the acceleration or deceleration.
  12. If the vibration is not reproduced, reinstall the brake rotors and the wheel/tire assemblies to put an additional load on the system. Check the components again while an assistant maintains the vehicle at the vibration concern speed.
  13. If the vibration is still not reproduced, lightly apply the brakes to further load the system while maintaining the vibration concern speed.
  14. If the pinion nose vibrates under acceleration or deceleration, and other driveline components have been eliminated as a cause, the vibration may be an internal axle problem.
scientia non olet · About LEMON Manuals