LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1461 (Propeller Shaft And Universal Joints) >> Repair Instructions >> Universal Joint Replacement - Nylon Injected Ring >> Assembly Procedure

Assembly Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the bearing cups from the universal joint.
    2. Fig 1: Assembling Trunnion Into Yoke
    GM1223Courtesy of GENERAL MOTORS CORP.
  2. Assemble 1 bearing cup part way into 1 side of the yoke.
  3. Turn the yoke ear toward the bottom.
  4. Assemble the cross into the yoke so the trunnion seats freely into the bearing cup.
  5. With the trunnion seated in the bearing cup, press the bearing cup into the yoke until the bearing cup is flush with the yoke ear.
    6. Fig 2: Installing Bearing Cup Into Yoke Ear
    GM1224Courtesy of GENERAL MOTORS CORP.
  6. Assemble the opposite bearing cup part way into the yoke ear.
  7. Ensure that the trunnions start straight and true into both bearing cups.
  8. Press the opposite bearing cup into the yoke ear while working the cross all the time in order to inspect for a free unbinding movement of the trunnions in the bearing cups.
    9. IMPORTANT: If there seems to be a hang up or binding, stop pressing, and inspect the needle bearings for misalignment in the bearing cup.
  9. Press the bearing cup into the yoke until the bearing retainer groove clears the inside of the yoke.
    10. Fig 3: Assembling Bearing Retainer In Retainer Groove
    GM1225Courtesy of GENERAL MOTORS CORP.
  10. Assemble the bearing retainer in the retainer groove.
  11. Continue pressing until you can snap both retainers into place.
    12. Fig 4: Springing Yoke Using Hammer
    GM1226Courtesy of GENERAL MOTORS CORP.
  12. If seating the retainer is difficult, spring the yoke slightly with a firm blow from a dead blow hammer.
  13. It may be necessary to lubricate the snap ring with a slight amount of chassis grease so the snap ring seats in the bearing cup groove.
scientia non olet · About LEMON Manuals