Removal Procedure
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
- Raise the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
- Reference mark the propeller shaft to the rear axle pinion yoke.
- Reference mark the propeller shaft to the transmission or transfer case.
- Remove the bolts and the yoke retainers from the rear axle pinion yoke.
- Slide the propeller shaft forward in order to disconnect the propeller shaft from the rear axle pinion yoke.
- Slide the propeller shaft rearward in order to disconnect the propeller shaft from the transmission or transfer case.
- Remove the propeller shaft.
IMPORTANT:
Observe and accurately reference mark all driveline components relative to the propeller shaft and axles before disassembly. These components include the propeller shafts, the drive axles, the pinion flanges, the output shafts, etc. All components must be reassembled in the exact relationship to each other as they were when removed. In addition, published specifications and torque values, as well as any measurements made prior to disassembly must be followed.
NOTE:
When removing the propeller shaft, do not attempt to remove the shaft by pounding on the yoke ears or using a tool between the yoke and the universal joint. If the propeller shaft is removed by using such means, the injection joints may fracture and lead to premature failure of the joint.