LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1461 (Propeller Shaft And Universal Joints) >> Repair Instructions >> Propeller Shaft Replacement - Rear >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Inspect the splines of the slip yoke for a sufficient coating of grease. If the splines of the slip yoke does not have a sufficient coating of grease, lubricate the shaft with grease (GM P/N 12377985 or equivalent).
    2. Fig 1: View Of Propeller Shaft To Transmission Or Transfer Case
    GM404287Courtesy of GENERAL MOTORS CORP.
  2. Install the propeller shaft into the transmission or transfer case.

    Align the reference marks made during removal.

    3. Fig 2: Rear Axle Pinion Yoke Assembly
    GM1247Courtesy of GENERAL MOTORS CORP.
  3. Install the propeller shaft to the rear axle pinion yoke.

    Align the reference marks made during removal.

    4. NOTE: Refer to Fastener Notice in Cautions and Notices.
  4. Install the yoke retainers and the bolts.

    Tighten:  Tighten the bolts to 20 N.m (15 lb ft).

  5. Lower the vehicle.
scientia non olet · About LEMON Manuals