LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1460 (Front Suspension System) >> Repair Instructions >> Wheel Hub, Bearing, and Seal Replacement (RWD) >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
  2. Remove the tire and wheel. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
  3. Remove the brake rotor. Refer to Brake Rotor Replacement - Front in Disc Brakes.
  4. Remove the ABS sensor mounting bolt from the wheel hub and bearing.
    Fig 1: Removing/Installing Wheel Speed Sensor Mounting Bolt
    GM743104Courtesy of GENERAL MOTORS CORP.
  5. Remove the ABS sensor from the wheel hub and bearing.
    6. Fig 2: Removing/Installing Wheel Hub & Bearing Bolts
    GM750558Courtesy of GENERAL MOTORS CORP.
  6. Remove the wheel hub and bearing to the steering knuckle mounting bolts.
    7. Fig 3: Removing/Installing Wheel Hub & Bearing
    GM750559Courtesy of GENERAL MOTORS CORP.
  7. Remove the wheel hub and bearing from the steering knuckle.
  8. Remove the splash shield from the steering knuckle.
scientia non olet · About LEMON Manuals