LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1460 (Front Suspension System) >> Repair Instructions >> Lower Ball Joint Replacement >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
  2. Remove the tire and wheel. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
  3. Remove the steering knuckle with wheel hub and bearing attached. Refer to Steering Knuckle Replacement (RWD)  or Steering Knuckle Replacement (4WD) .
  4. Remove the lower ball joint flange with a chisel.
    Fig 1: Removing Lower Ball Joint Flange
    GM744329Courtesy of GENERAL MOTORS CORP.
    5. Fig 2: Removing Lower Ball Joint
    GM751168Courtesy of GENERAL MOTORS CORP.
  5. Install J 9519-E  and J 34874  to the lower ball joint. See Special Tools and Equipment .
  6. Remove the lower ball joint from the lower control arm using J 9519-E  and J 34874  . See Special Tools and Equipment .
scientia non olet · About LEMON Manuals