LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1459 (Rear Drive Axle) >> Repair Instructions >> Vent Hose Replacement >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Removing/Installing Vent Hose From Clip
    GM788624Courtesy of GENERAL MOTORS CORP.
  1. Install the vent hose to the clip attached to the frame.
    • Route the same way as when removed.
    • Ensure that the hose is free of kinks and is routed clear of sharp objects.
    • Ensure that the vent is not plugged.
    2. Fig 2: Rear Axle Vent Hose
    GM788622Courtesy of GENERAL MOTORS CORP.
  2. Install the vent hose to the top of the rear axle.
  3. Lower the vehicle.
scientia non olet · About LEMON Manuals