LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1459 (Rear Drive Axle) >> Repair Instructions >> Rear Axle Shaft Seal and/or Bearing Replacement >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
  2. Remove the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
  3. Remove the rear axle housing cover and the gasket. Refer to Rear Axle Housing Cover and Gasket Replacement  .
  4. Remove the axle shaft. Refer to Rear Axle Shaft Replacement  .
    5. Fig 1: Removing Axle Shaft Seal And/Or Bearing
    GM688157Courtesy of GENERAL MOTORS CORP.
  5. Remove the axle shaft seal and/or the bearing from the axle housing using the J 44685  (1) and the. See Special Tools and Equipment .J 2619-01  (2).
scientia non olet · About LEMON Manuals