LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1459 (Rear Drive Axle) >> Repair Instructions >> Rear Axle Shaft Seal and/or Bearing Replacement >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Installing Axle Shaft Bearing Using J 23690 & J 8092
    GM695758Courtesy of GENERAL MOTORS CORP.
  1. Install the axle shaft bearing using the J 23690  (1) and the J 8092  (2).
  2. Drive the axle shaft bearing into the axle housing until the tool bottoms against the tube.
    3. Fig 2: Driving J 21128 Or J 29713 Into The Bore Until The Axle Shaft Seal Bottoms Flush With The Tube
    GM695762Courtesy of GENERAL MOTORS CORP.
  3. Install the axle shaft seal using the J 21128  . See Special Tools and Equipment .
  4. Drive the tool into the bore until the axle shaft seal bottoms flush with the tube.
  5. Install the axle shaft. Refer to Rear Axle Shaft Replacement  .
  6. Install the rear axle housing cover and the gasket. Refer to Rear Axle Housing Cover and Gasket Replacement  .
  7. Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
  8. Fill the rear axle with axle lubricant. Use the proper fluid. Refer to Lubricant Replacement - Rear Drive Axle  .
  9. Lower the vehicle.
scientia non olet · About LEMON Manuals