LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1459 (Rear Drive Axle) >> Repair Instructions >> Differential Side Bearings Replacement >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the differential. Refer to Differential Replacement  .
    2. Fig 1: Removing Differential Side Bearing
    GM680400Courtesy of GENERAL MOTORS CORP.
  2. Remove the differential side bearings by performing the following steps:
    1. Install the differential assembly in a vise.
    2. Install the J 22888-20A  (2) and the J 8107-2  , 8.0 inch axle, or the J 8107-4 , 8.6 inch axle (1), as shown. See Special Tools and Equipment .
    3. Remove the differential side bearings using the J 22888-20A  .
  3. Remove the differential assembly from the vise.
scientia non olet · About LEMON Manuals