LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1457 (Disc Brake System) >> Repair Instructions >> Brake Caliper Overhaul - Rear >> Assembly Procedure

Assembly Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Lubricating Piston Seal, Caliper Bore & Piston With Clean Brake Fluid
    GM311242Courtesy of GENERAL MOTORS CORP.
  1. Lubricate the new piston seal, the caliper bore, and the piston with clean brake fluid.
    2. Fig 2: Removing/Installing Piston Seal
    GM311224Courtesy of GENERAL MOTORS CORP.
  2. Install the piston seal. Make sure the piston seal is not twisted in the caliper bore groove.
  3. Install the boot into the caliper housing bore by hand.
  4. Install the piston in the caliper bore. Push the piston to the bottom of the bore by hand.
    5. Fig 3: Installing Piston & Piston Boot
    GM147Courtesy of GENERAL MOTORS CORP.
  5. Install the boot on the piston.
scientia non olet · About LEMON Manuals