Disc Brake Mounting and Hardware Inspection - Front
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
Refer to Brake Dust Caution
in Cautions and Notices.
- Remove the disc brake caliper from the caliper mounting bracket. Refer to Brake Caliper Replacement - Front .
- Remove the disc brake pads from the caliper mounting bracket.
- Inspect the disc brake pad mounting hardware for the following:
- Missing mounting hardware
- Excessive corrosion
- Bent mounting tabs
- Looseness at the caliper mounting bracket
- Looseness at the disc brake pads
- If any of the conditions listed are found, the disc brake pad mounting hardware requires replacement.
- Ensure the disc brake pads are held firmly in place on the caliper mounting bracket, yet slide easily on the mounting hardware without binding.
- Install the disc brake pads to the caliper mounting bracket.
- Install the disc brake caliper to the mounting bracket. Refer to Brake Caliper Replacement - Front