LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1456 (Power Steering System) >> Repair Instructions >> Steering Gear Cylinder Pipe Assemblies/O-Ring Seals Replacement - Off Vehicle >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
    IMPORTANT: Protect the boots from sharp tools and from the sharp edges of surrounding components.
  1. Remove the TORX® screw (1) from the cylinder line retaining plate (2) at the valve end.
  2. Remove the cylinder line retaining plate (2).
    Fig 1: Removing Cylinder Line Retaining Plate
    GM796366Courtesy of GENERAL MOTORS CORP.
    3. Fig 2: Removing Cylinder Line Assemblies
    GM796368Courtesy of GENERAL MOTORS CORP.
  3. Loosen both cylinder line nuts (3) on cylinder end of the gear assembly (1).
  4. Remove both cylinder line assemblies (2) from the rack and pinion gear assembly (1).
  5. Remove and discard the O-rings seals (4) from the valve end (5).
scientia non olet · About LEMON Manuals