LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1456 (Power Steering System) >> Repair Instructions >> Power Steering Pump Replacement (5.3L) >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the drive belt. Refer to Drive Belt Replacement - Accessory in Engine Mechanical - 4.8L, 5.3L and 6.0L.
  2. Remove the PCM from PCM mounting bracket and move to the side. Refer to Powertrain Control Module (PCM) Replacement in Engine Controls - 4.8L, 5.3L and 6.0L.
    3. Fig 1: View Of Power Steering Pressure Hose, Return Hose & Pump
    GM841009Courtesy of GENERAL MOTORS CORP.
  3. Remove the power steering pressure hose (1) from power steering pump (2).
  4. Remove the power steering pump return hose (3) from power steering pump (2).
    5. Fig 2: Removing/Installing Power Steering Pump
    GM841012Courtesy of GENERAL MOTORS CORP.
  5. Remove the power steering pump mounting bolts (3).
  6. Remove the power steering pump (1).
  7. Remove the power steering pump pulley. Refer to Power Steering Pulley Replacement (5.3L)  or Power Steering Pulley Replacement (4.2L) .
  8. If applicable, remove the power steering pump reservoir. Refer to Power Steering Reservoir Replacement - Off Vehicle (CB Series) .
scientia non olet · About LEMON Manuals