LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1456 (Power Steering System) >> Repair Instructions >> Power Steering Cooler Replacement (4.2L) >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Removing/Installing Power Steering Cooler
    GM687449Courtesy of GENERAL MOTORS CORP.
  1. Install the power steering cooler to the radiator support.
    2. Fig 2: Removing/Installing Power Steering Cooler Mounting Bolts
    GM687448Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the power steering cooler mounting bolts.

    Tighten:  Tighten the power steering cooler mounting bolts to 20 N.m (15 lb ft).

    3. Fig 3: View Of Power Steering Hose Assembly At Power Steering Cooler
    GM687441Courtesy of GENERAL MOTORS CORP.
  3. Connect the power steering hoses assembly to the power steering cooler.
  4. Remove drain pan from under the vehicle.
scientia non olet · About LEMON Manuals