Struts or Shock Absorbers On-Vehicle Testing
WARNING: This page is about a different car, the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
Struts or Shock Absorbers On-Vehicle Testing
| Step | Action | Yes | No |
|---|---|---|---|
| 1 | Did you review the General Description and perform the necessary inspections? | Go to Step 2 | Go to Symptoms - Suspension General Diagnosis |
| 2 | Verify that the customer's concern is present. Does the vehicle operate normally? |
System OK | Go to Step 3 |
| 3 |
IMPORTANT:
A light film of oil on the top portion of the shock reservoir is normal. Inspect each shock absorber for external fluid leakage.Is a shock absorber leaking? |
Go to Step 5 | Go to Step 4 |
| 4 |
|
Go to Step 5 | Go to Step 6 |
| 5 |
IMPORTANT:
Inspect the vehicle trim height in order to correct any possible causes of shock/strut failures. Refer to Trim Height Inspection Procedure
. Replace the shock absorber. Refer to Shock Module Replacement
or Shock, Shock Component, and/or Spring Replacement
in Front Suspension or Shock Absorber Replacement
in Rear Suspension.Did you complete the repair? |
Go to Step 6 | - |
| 6 | Operate the vehicle in order to verify the repair. Did you correct the condition? |
System OK | Go to Step 3 |