LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1455 (Suspension System General Diagnosis) >> Diagnostic Information and Procedures >> Poor Directional Stability

Poor Directional Stability

WARNING: This page is about a different car, the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
Poor Directional Stability

Step Action Yes No
DEFINITION: Driver is unable to maintain consistent, predictable vehicle driving control in any direction.
1 Did you review the General Description and perform the necessary inspections? Go to Step 2  Go to Symptoms - Suspension General Diagnosis 
2 Verify that the directional stability is poor.
Does the system operate normally?
System OK Go to Step 3 
3 Inspect the front stabilizer for the following conditions:
Did you find and correct the condition?
Go to Step 10  Go to Step 4 
4 Inspect the following suspension and steering components for wear or damage:
Did you find and correct the condition?
Go to Step 10  Go to Step 5 
5 Inspect the wheel bearing. Refer to Wheel Bearings Diagnosis  .
Did you find and correct the condition?
Go to Step 10  Go to Step 6 
6 Inspect the vehicle trim height. Refer to Trim Height Inspection Procedure  .
Did you find and correct the condition?
Go to Step 10  Go to Step 7 
7 Inspect the steering column for looseness. Refer to Looseness in Steering Column in Steering Wheel and Column.
Did you find and correct the condition?
Go to Step 10  Go to Step 8 
8 Inspect the steering gear for the following conditions:
Steering gear mounting bolts for looseness. Refer to Fastener Tightening Specifications in Power Steering.
Did you find and correct the condition?
Go to Step 10  Go to Step 9 
9 Inspect and adjust the wheel alignment as necessary. Refer to Measuring Wheel Alignment in Wheel Alignment.
Did you complete the alignment?
Go to Step 10  -
10 Operate the vehicle in order to verify the repair.
Did you correct the condition?
System OK Go to Step 3