LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1453 (Suspension Control System - Suspension Leveling) >> Diagnostic Information and Procedures >> Rear Air Springs Do Not Inflate

Rear Air Springs Do Not Inflate

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
Rear Air Springs Do Not Inflate

Step Action Yes No
Schematic Reference: Suspension Controls Schematics 
1 Did you perform the Air Suspension Diagnostic System Check? Go to Step 2  Go to Diagnostic System Check - Air Suspension 
2 Verify the fault is present.
Does the system operate normally?
Go to Testing for Intermittent Conditions and Poor Connections in Wiring Systems Go to Step 3 
3
  1. Turn OFF the ignition.
  2. Disconnect the Air Suspension Compressor Assembly.
  3. Turn ON the ignition, with the engine OFF.
  4. Connect a test lamp between the ground circuit of the Air Suspension Compressor Assembly and a battery positive voltage circuit.
Does the test lamp illuminate?
Go to Step 4  Go to Step 7 
4 Test the battery positive voltage circuit of the Air Suspension Compressor Assembly for an open, short to ground and high resistance. Refer to Circuit Testing , Testing for Short to Ground or Testing for Intermittent Conditions and Poor Connections in Wiring Systems.
Did you find and correct the condition?
Go to Step 9  Go to Step 5 
5 Test the ignition 3 voltage circuit of the Air Suspension Compressor Assembly for an open, short to ground and high resistance. Refer to Circuit Testing , Testing for Short to Ground or Testing for Intermittent Conditions and Poor Connections in Wiring Systems.
Did you find and correct the condition?
Go to Step 9  Go to Step 6 
6 Inspect for poor connections at the harness connector of the Air Suspension Compressor Assembly.
Did you find and correct the condition?
Go to Step 9  Go to Step 8 
7 Repair the open in the Air Suspension Compressor Assembly ground circuit.
Did you complete the repair?
Go to Step 9  -
8 Replace the Air Suspension Compressor Assembly.
Refer to Air Spring Compressor Replacement  .
Did you complete the replacement?
Go to Step 9  -
9 Operate the system in order to verify the repair.
Did you correct the condition?
System OK Go to Step 3