Installation Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.

Install the park brake warning lamp switch.

Fig 1: Locating Park Brake Warning Lamp Switch

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the park brake warning lamp switch retaining screw.
Tighten: Tighten the park brake warning lamp switch mounting bolt to 4 N.m (35 lb in).
Connect the electrical connector.

Fig 2: Removing/Installing Front Bucket Seat

Courtesy of GENERAL MOTORS CORP.

Install the front passenger side seat. Refer to Seat Replacement - Front Bucket in Seats.