LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1450 (Parking Brake System) >> Repair Instructions >> Park Brake Lever Assembly Replacement >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Console Assembly
    GM741613Courtesy of GENERAL MOTORS CORP.
  1. Remove the floor console. Refer to Console Replacement in Instrument Panel, Gages and Console.
  2. Disable the Park Brake Automatic Adjuster. Refer to Disabling the Park Brake Cable Automatic Adjuster .
  3. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
  4. Fig 2: Locating Park Brake Cable Equalizer
    GM778146Courtesy of GENERAL MOTORS CORP.
  5. Disconnect the park brake cables from the equalizer.
  6. Lower the vehicle.
  7. Disconnect the electrical connector from the park brake warning lamp switch.
  8. Fig 3: Removing/Installing Park Brake Lever
    GM748000Courtesy of GENERAL MOTORS CORP.
  9. Remove the remaining park brake lever retaining nut.
  10. Remove the park brake lever assembly from the vehicle.