LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1450 (Parking Brake System) >> Repair Instructions >> Park Brake Lever Assembly Replacement >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Removing/Installing Park Brake Lever
    GM748000Courtesy of GENERAL MOTORS CORP.
  1. Install the park brake lever assembly to the vehicle.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the right front park brake lever retaining nut.

    Tighten:  Tighten the park brake lever mounting nut to 25 N.m (18 lb ft).

  3. Connect the electrical connector to the park brake warning lamp switch.
  4. Raise the vehicle.
    5. Fig 2: Locating Park Brake Cable Equalizer
    GM778146Courtesy of GENERAL MOTORS CORP.
  5. Connect the park brake cables to the equalizer.
  6. Lower the vehicle.
    7. Fig 3: Identifying Console Assembly
    GM741613Courtesy of GENERAL MOTORS CORP.
  7. Install the floor console. Refer to Console Replacement in Instrument Panel, Gages and Console.
  8. Enable the park brake automatic adjuster. Refer to Enabling the Park Brake Cable Automatic Adjuster .
scientia non olet · About LEMON Manuals