LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1450 (Parking Brake System) >> Repair Instructions >> Park Brake Cable Replacement >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Installing Park Brake Cables Over Fuel Tank
    GM777356Courtesy of GENERAL MOTORS CORP.
  1. Install the park brake cables over the fuel tank assembly.
    2. Fig 2: Pulling Park Brake Cable Through Frame
    GM777357Courtesy of GENERAL MOTORS CORP.
  2. Pull the park brake cable through the frame toward the outside of the vehicle.
    3. Fig 3: Removing/Installing Park Brake Cable Retaining Nuts
    GM777355Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the park brake cable retaining nuts to the underbody mounting studs.

    Tighten:  Tighten the park brake cable retaining nuts to 10 N.m (7 lb ft).

  4. Raise the fuel tank.
  5. Install the rear support bracket for the fuel tank.
  6. Remove the pole jack and the block of wood from the fuel tank.
    7. Fig 4: View Of Parking Brake Cable
    GM777351Courtesy of GENERAL MOTORS CORP.
  7. Install the park brake cable on the actuator.
  8. Depress the retaining clips for the park brake cable.
    9. Fig 5: Installing Park Brake Retainer To Frame (Left Rear Shown)
    GM777470Courtesy of GENERAL MOTORS CORP.
  9. Install the park brake retainer to the frame (left rear shown).
    10. Fig 6: Locating Park Brake Retaining Bracket Bolt At Frame
    GM777399Courtesy of GENERAL MOTORS CORP.
  10. Install the park brake retaining bracket bolt in the frame.

    Tighten:  Tighten park brake cable retaining bracket bolt to 20 N.m (15 lb ft).

    11. Fig 7: Removing/Installing Park Brake Cable At Park Brake Cable Retainers (Left Rear Shown)
    GM777353Courtesy of GENERAL MOTORS CORP.
  11. Install the park brake cable to the park brake cable retainers, left rear shown.
    12. Fig 8: Locating Fuel Tank Shield
    GM730787Courtesy of GENERAL MOTORS CORP.
  12. Install the shield for the fuel tank. Refer to Fuel Tank Shield Replacement (TrailBlazer, Envoy) or Fuel Tank Shield Replacement (TrailBlazer EXT, Envoy XL) in Frame and Underbody.
    13. Fig 9: Locating Park Brake Cable Equalizer
    GM778146Courtesy of GENERAL MOTORS CORP.
  13. Install the park brake cables to the retainer.
    14. Fig 10: Locating Park Brake Cable Equalizer
    GM778141Courtesy of GENERAL MOTORS CORP.
  14. Install the park brake cables to the park brake equalizer.
    15. Fig 11: Location Of Drive Shaft
    GM746665Courtesy of GENERAL MOTORS CORP.
  15. Install the rear propeller shaft. Refer to Propeller Shaft Replacement - Rear in Propeller Shaft.
  16. Lower the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
  17. Enable the park brake automatic adjuster. Refer to Enabling the Park Brake Cable Automatic Adjuster .
  18. Test the park brake operation.
  19. Adjust the park brake shoes. Refer to Park Brake Adjustment .
scientia non olet · About LEMON Manuals