LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1449 (Automatic Transmission - 4L60-E/4L65-E (Introduction, Service & Replacement)) >> Repair Instructions >> Vehicle Speed Sensor (VSS) Replacement >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of VSS, Bolt & O-Ring Seal
    GM481937Courtesy of GENERAL MOTORS CORP.
  1. Install the O-ring seal (3) on the vehicle speed sensor (1).
  2. Coat the O-ring seal (3) with a thin film of transmission fluid.
  3. Install the vehicle speed sensor (1) into the transmission case.
    4. NOTE: Refer to Fastener Notice in Cautions and Notices.
  4. Install the bolt (2).

    Tighten:  Tighten the bolt to 11 N.m (97 lb in).

  5. Connect the wiring harness electrical connector to the vehicle speed sensor.
  6. Refill the fluid as required.
scientia non olet · About LEMON Manuals