LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1449 (Automatic Transmission - 4L60-E/4L65-E (Introduction, Service & Replacement)) >> Repair Instructions >> Transmission Mount Replacement (5.3L) >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Transmission Mount (5.3L)
    GM1293472Courtesy of GENERAL MOTORS CORP.
  1. Install the transmission mount.
    2. Fig 2: View Of Transmission Mount Bolts (5.3L)
    GM1293735Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the bolts (1, 2) securing the transmission mount to the transmission.

    Tighten:  Tighten the bolts to 65 N.m (48 lb ft).

    3. Fig 3: View Of Transmission Crossmember Support
    GM752134Courtesy of GENERAL MOTORS CORP.
  3. Install the transmission support to the vehicle. Refer to Transmission Support Replacement in Frame and Underbody.
    4. Fig 4: View Of Transmission Mount To Transmission Support
    GM744176Courtesy of GENERAL MOTORS CORP.
  4. Remove the transmission jack.
  5. Install the nuts securing the transmission mount to the transmission support.

    Tighten:  Tighten the nuts to 46 N.m (35 lb ft).

  6. Lower the vehicle.
scientia non olet · About LEMON Manuals