LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1449 (Automatic Transmission - 4L60-E/4L65-E (Introduction, Service & Replacement)) >> Repair Instructions >> Floor Shift Control Replacement >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Transmission Control & Bolts
    GM745783Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  1. Install the transmission control.
  2. Install the transmission control bolts.

    Tighten:  Tighten the transmission control bolts to 25 N.m (18 lb ft).

    3. Fig 2: View Of shift Control Cable & Shifter
    GM744173Courtesy of GENERAL MOTORS CORP.
  3. Install the range selector cable (2) to the floor shift control.
  4. Install the end of the range selector cable (1) to the transmission control ball stud.
  5. Connect the shift lock control solenoid wiring harness.
    6. Fig 3: Removing/Installing Center Console Assembly
    GM1234306Courtesy of GENERAL MOTORS CORP.
  6. Install the front floor console. Refer to Console Replacement in Instrument Panel, Gauges and Console.
  7. Check for proper operation of the floor shift control.
  8. Adjust the range selector cable if necessary. Refer to Automatic Transmission Range Selector Cable Adjustment  .
scientia non olet · About LEMON Manuals