LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1449 (Automatic Transmission - 4L60-E/4L65-E (Introduction, Service & Replacement)) >> Repair Instructions >> Floor Shift Control Knob Replacement >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Floor Shift Control Knob & Boot Assembly
    GM744528Courtesy of GENERAL MOTORS CORP.
  1. The floor shift control knob and boot are serviced as an assembly.
  2. Loosen the set screw (3) or (1) for Oldsmobile models.
  3. Push in at the base of the boot to release the locking tabs (2) from the console assembly.
  4. Pull up to remove the knob and boot assembly from the transmission control (4).
scientia non olet · About LEMON Manuals