LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1449 (Automatic Transmission - 4L60-E/4L65-E (Introduction, Service & Replacement)) >> Repair Instructions >> Floor Shift Control Knob Replacement >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Floor Shift Control Knob & Boot Assembly
    GM744528Courtesy of GENERAL MOTORS CORP.
  1. Install the knob and boot assembly onto the transmission control (4).
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Engage the locking tabs (2) with the console assembly.

    Tighten:  Tighten the control knob set screw (1 or 3) to 2 N.m (18 lb in).

scientia non olet · About LEMON Manuals