LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1449 (Automatic Transmission - 4L60-E/4L65-E (Introduction, Service & Replacement)) >> Repair Instructions >> Automatic Transmission Range Selector Cable Adjustment >> Adjustment Procedure

Adjustment Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Range Selector Cable
    GM744174Courtesy of GENERAL MOTORS CORP.
  1. Ensure that the range selector cable is not restricted.
  2. Ensure that the floor shift control is in the PARK position.
  3. Raise the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
  4. Disconnect the range selector cable (4) from the range selector lever ball stud (6).
  5. Ensure that the range selector lever is in the mechanical PARK position. (Rotate the range selector lever fully clockwise).
    6. Fig 2: View Of Secondary Lock Tab
    GM1209786Courtesy of GENERAL MOTORS CORP.
  6. Release the locking tab (1)
    7. Fig 3: View Of Secondary Lock Cover & Locking Tabs
    GM1209788Courtesy of GENERAL MOTORS CORP.
  7. Slide the secondary lock cover (1) to the side
  8. Carefully squeeze the locking tabs (2) together to disengage the primary lock.
    9. Fig 4: View Of Primary Lock
    GM1209789Courtesy of GENERAL MOTORS CORP.
  9. Pull the primary lock (1) up. Spring tension will push the end of the cable past the ball stud.
    10. IMPORTANT: If the cable end is pushed rearward past the ball stud during the adjustment procedure, it must be released and allowed to come forward of the ball stud. The cable end must then be pushed back just enough to be installed to the ball stud.
  10. Push the end of the cable until it is aligned with the ball stud.
    11. Fig 5: Identifying Range Selector Cable
    GM744174Courtesy of GENERAL MOTORS CORP.
  11. Install the cable (4) to the ball stud (6).
    12. Fig 6: View Of Primary Lock
    GM1209789Courtesy of GENERAL MOTORS CORP.
  12. Seat the primary lock (1) by pressing into the locked position.
    13. Fig 7: View Of Secondary Lock Cover & Locking Tabs
    GM1209788Courtesy of GENERAL MOTORS CORP.
  13. Slide the secondary lock (1) over the primary lock.
    14. Fig 8: View Of Secondary Lock Tab
    GM1209786Courtesy of GENERAL MOTORS CORP.
  14. Be sure that the secondary lock tab (1) is securely in place.
  15. Lower the vehicle.
  16. Check the vehicle for proper operation.
scientia non olet · About LEMON Manuals