LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1448 (HVAC Systems - General Servicing) >> Repair Instructions >> Air Outlet Replacement - Instrument Panel - Center >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Removing Installing Outlet From Vehicle
    GM957231Courtesy of GENERAL MOTORS CORP.
  1. If reinstalling the original outlet, install the air deflectors in the outlet. Refer to Air Outlet Replacement - Instrument Panel .
  2. Install the outlet assembly to the I/P.
    3. Fig 2: 2 Screws From Bottom Of Air Outlet Assembly
    GM957271Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the 2 retaining screws (1).

    Tighten:  Tighten the screws to 2.5 N.m (22 lb in).

  4. Install the radio. Refer to Radio Replacement in Entertainment.
  5. Install the I/P cluster bezel, Chevrolet only. Refer to Bezel Replacement - Instrument Panel (I/P) Cluster (Chevrolet) or Bezel Replacement - Instrument Panel (I/P) Cluster (GMC/Oldsmobile/Buick) in Instrument Panel, Gages, and Console.
  6. Install the knee bolster trim panel. Refer to Trim Panel Replacement - Knee Bolster Instrument Panel, Gages, and Console.
  7. Install the left closeout/insulator panel. Refer to Closeout/Insulator Panel Replacement - Left Instrument Panel, Gages, and Console.
scientia non olet · About LEMON Manuals