LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1445 (Hydraulic Brake System) >> Repair Instructions >> Brake Pedal Assembly Replacement >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the closeout/insulator panel. Refer to Closeout/Insulator Panel Replacement - Left in Instrument Panel, Gages, and Console.
  2. Remove the stoplamp switch from the brake pedal. Refer to Stop Lamp Switch Replacement in Lighting Systems.
    3. Fig 1: Identifying Brake Pedal Pivot Bolt
    GM343641Courtesy of GENERAL MOTORS CORP.
  3. Remove the brake pedal pivot bolt and discard the bolt.
  4. Remove the brake pedal.
  5. Inspect the brake pedal pivot bushing for damage or wear.
scientia non olet · About LEMON Manuals