LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1445 (Hydraulic Brake System) >> Repair Instructions >> Brake Hose Replacement - Front >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Brake Hose At Frame
    GM789334Courtesy of GENERAL MOTORS CORP.
  1. Remove the brake hose retaining bolt from the frame.
    2. Fig 2: Capping Off Brake Hose
    GM846444Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Install a rubber cap or plug the exposed brake pipe fitting ends will prevent brake fluid loss and contamination.
  2. Install a rubber cap or plug on the brake pipe fitting.
    3. Fig 3: View Of Banjo Fitting To Caliper
    GM355084Courtesy of GENERAL MOTORS CORP.
  3. Remove the brake hose bolt from the brake caliper assembly.
  4. Remove the brake hose from the vehicle.
    5. IMPORTANT: The metal gaskets may be stuck to either the brake caliper or the brake hose end. Ensure that these gaskets are removed from the brake hose end and the brake caliper.
  5. Remove and discard the copper gaskets.
scientia non olet · About LEMON Manuals