Installation Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Banjo Fitting To Caliper

Courtesy of GENERAL MOTORS CORP.

IMPORTANT: DO NOT reuse the old copper gaskets. Use only NEW copper gaskets.

Install the NEW copper gaskets to the brake hose and bolt.
Install the brake hose bolt to the brake caliper.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the brake hose to brake caliper.
Tighten: Tighten the brake hose bolt to 44 N.m (33 lb ft).

Fig 2: Identifying Brake Hose At Frame

Courtesy of GENERAL MOTORS CORP.

Install the brake hose retaining bolt to the frame.
Tighten: Tighten the brake hose bolt to 20 N.m (18 lb ft).

Fig 3: Removing Brake Hose Cap

Courtesy of GENERAL MOTORS CORP.

Remove the rubber cap or plug from the brake pipe fitting.

Fig 4: Installing Brake Pipe To Brake Hose

Courtesy of GENERAL MOTORS CORP.

Install the brake pipe to the brake hose.
Tighten: Tighten the brake pipe fitting to 20 N.m (18 lb ft).

Fig 5: View Of Full Master Cylinder Reservoir MAX And MIN Marks

Courtesy of GENERAL MOTORS CORP.

Fill the brake master cylinder reservoir. Refer to Master Cylinder Reservoir Filling .
Bleed the hydraulic brake system. Refer to Hydraulic Brake System Bleeding (Manual) Hydraulic Brake System Bleeding (Pressure) .
Install the front tires and wheels assembly. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
Lower the vehicle. Refer toLifting and Jacking the Vehicle in General Information.