LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1444 (Engine Mechanical - 5.3L (Lm4)) >> Repair Instructions >> On-Vehicle Repair Instructions >> Engine Mount Replacement - Right (4 Wheel Drive) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 Chevrolet TrailBlazer, and 2004 Buick Rainier. However, it is still accessible from the selected car via links, so may be relevant.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
    Fig 1: View Of Engine Mounting Bracket
    GM883055Courtesy of GENERAL MOTORS CORP.
  1. Install the engine mount bracket spacer if it has been replaced.

    Tighten:  Torque the engine mount spacer bolts to 50 N.m (37 lb ft).

    2. Fig 2: View Of Engine Mount
    GM886135Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Make sure that the cut out side of the engine mount shield is positioned away from the engine.
  2. Install the engine mount to the upper engine mount bracket.

    Tighten:  Tighten the engine mount nuts to 50 N.m (37 lb ft)

    3. Fig 3: Identifying Upper Engine Mount Assembly
    GM876736Courtesy of GENERAL MOTORS CORP.
  3. Install the engine mount to engine.

    Tighten:  Torque the engine mount bolts to 50 N.m (37 lb ft).

  4. Install the engine mount frame bracket to the frame.
  5. Install the engine mount frame bracket retaining bolts.

    Tighten:  Torque the engine mount frame bracket retaining bolts to 100 N.m (74 lb ft).

  6. Shift the engine back towards the right side of the frame.
  7. Install the left side engine mount frame bracket.
  8. Install the left side engine mount frame bracket retaining bolts.

    Tighten:  Torque the left side engine mount frame bracket retaining bolts to 100 N.m (74 lb ft).

    9. Fig 4: View Of Left Lower Engine Mount
    GM876682Courtesy of GENERAL MOTORS CORP.
  9. Lower the engine, making sure to align engine mount studs with holes in frame bracket.
  10. Remove the pole jack and block of wood.
  11. Tighten the engine mount nuts.

    Tighten:  Torque the engine mount nuts to 50 N.m (37 lb ft).

  12. Install the shock module. Refer to Shock Module Replacement in Front Suspension.
  13. Install the front differential carrier. Refer to Differential Carrier Assembly Replacement (4.8L, 5.3L, 6.0L V-8) in Front Drive Axle.
  14. Install the left side wheel drive shaft. Refer to Wheel Drive Shaft Replacement in Wheel Drive Shafts.
  15. Install the Engine Protection Shield. Refer to Engine Protection Shield Replacement in Frame and Underbody.
  16. Install the front tire and wheels. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
  17. Lower the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
scientia non olet · About LEMON Manuals