Installation Procedure
WARNING: This page is about a different car, the 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 Chevrolet TrailBlazer, and 2004 Buick Rainier. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:
- The flywheel spacer (if applicable) must be removed prior to oil seal installation.
- Do not lubricate the oil seal inside diameter (ID) or the crankshaft surface.
- Do not reuse the crankshaft rear oil seal.
- Lubricate the outside diameter (OD) of the oil seal (1) with clean engine oil.
DO NOT allow oil or other lubricants to contact the seal surface.
- Lubricate the rear cover oil seal bore with clean engine oil.
DO NOT allow oil or other lubricants to contact the crankshaft surface.
- Install the J 41479 tapered cone (2) and bolts onto the rear of the crankshaft. See Special Tools and Equipment .
- Tighten the bolts until snug. Do not overtighten.
- Install the rear oil seal onto the tapered cone (2) and push the seal to the rear cover bore.
- Thread the J 41479 threaded rod into the tapered cone until the tool (1) contacts the oil seal. See Special Tools and Equipment .
- Align the oil seal into the tool (1).
- Rotate the handle of the tool (1) clockwise until the seal enters the rear cover and bottoms into the cover bore.
- Remove the J 41479 . See Special Tools and Equipment .
- Install the engine flywheel. Refer to Engine Flywheel Replacement .