LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1444 (Engine Mechanical - 5.3L (Lm4)) >> Repair Instructions >> Off-Vehicle Repair Instructions >> Water Pump Cleaning and Inspection

Water Pump Cleaning and Inspection

WARNING: This page is about a different car, the 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 Chevrolet TrailBlazer, and 2004 Buick Rainier. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Water Pump, Gaskets & Bolts
    GM260121Courtesy of GENERAL MOTORS CORP.
  1. Remove the old gasket from the water pump sealing surfaces. Refer to Replacing Engine Gaskets  .
  2. Clean all excess dirt and debris from the water pump housing.
  3. Inspect the water pump for the following:
    • Gasket and hose sealing surfaces for excessive scratches or gouging
    • Restrictions within the internal coolant passages
    • Excessive side-to-side play in the pulley shaft
    • Leakage at the water outlet housing or rear cover gasket
    • Leakage at the water pump vent hole

      A stain around the vent hole is acceptable. If leakage, dripping, occurs with the engine running and the cooling system pressurized, replace the water pump.

    4. Fig 2: Inspecting Water Pump Pulley For Wear Or Damage
    GM260124Courtesy of GENERAL MOTORS CORP.
  4. Inspect the water pump pulley for wear or damage in the belt tracking area.
scientia non olet · About LEMON Manuals