LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1444 (Engine Mechanical - 5.3L (Lm4)) >> Repair Instructions >> Off-Vehicle Repair Instructions >> Valve Rocker Arm Cover Cleaning and Inspection

Valve Rocker Arm Cover Cleaning and Inspection

WARNING: This page is about a different car, the 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 Chevrolet TrailBlazer, and 2004 Buick Rainier. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Ignition Coils
    GM824413Courtesy of GENERAL MOTORS CORP.
    IMPORTANT:
    • Do not use the valve rocker arm cover gasket again. Install a NEW gasket during assembly.
    • Remove the ignition coils before cleaning the cover in solvent. Do not submerge the ignition coils in solvent.
    • Do not remove the oil fill tube or crankcase vent valve grommet from the covers unless service is required.
    • If the oil fill tube or crankcase vent valve grommet has been removed from the rocker arm covers, install a NEW tube or grommet during assembly.
  1. Remove the ignition coil and bracket assembly, bolts, and wire harness from the left cover, if required.
    2. Fig 2: Ignition Coil View
    GM825840Courtesy of GENERAL MOTORS CORP.
  2. Remove the ignition coil and bracket assembly, bolts, and wire harness from the right cover, if required.
    3. Fig 3: View Of Oil Fill Cap & Tube
    GM260110Courtesy of GENERAL MOTORS CORP.
  3. Inspect the tube for a loose fit or damage.
  4. Remove the oil fill cap and tube from the right cover, if required.
    5. Fig 4: View Of Valve Rocker Arm Cover Gasket
    GM1272820Courtesy of GENERAL MOTORS CORP.
  5. Remove the gaskets (504) from the covers.
  6. Remove the cover mounting bolts, with grommets.

    Cover mounting bolts and grommets that are not damaged may be used again during assembly.

  7. Clean the covers in solvent.
    8. Fig 5: Valve Cover To Cylinder Head View
    GM260085Courtesy of GENERAL MOTORS CORP.
    CAUTION: Refer to Safety Glasses Caution in Cautions and Notices.
  8. Dry the covers with compressed air.
  9. Inspect the ventilation system passages for restrictions.
  10. Inspect the gasket grooves for damage.
  11. Inspect the coil bracket threaded bolt holes for damage or debris.
scientia non olet · About LEMON Manuals