LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1444 (Engine Mechanical - 5.3L (Lm4)) >> Repair Instructions >> Off-Vehicle Repair Instructions >> Engine Front Cover Cleaning and Inspection

Engine Front Cover Cleaning and Inspection

WARNING: This page is about a different car, the 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 Chevrolet TrailBlazer, and 2004 Buick Rainier. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Crankshaft Front Oil Seal
    GM1272843Courtesy of GENERAL MOTORS CORP.
    IMPORTANT:
    • Do not use the crankshaft oil seal again. Install a NEW crankshaft oil seal during assembly.
    • Do not use the front cover-to-engine block gasket again. Install a NEW gasket during assembly.
  1. Remove the crankshaft oil seal (140) from the front cover.
  2. Clean the cover in solvent. Remove the sealant from the cover oil pan surface. Refer to Replacing Engine Gaskets  .
    3. CAUTION: Refer to Safety Glasses Caution in Cautions and Notices.
  3. Dry the cover with compressed air.
  4. Inspect the gasket sealing surfaces for excessive scratches or gouging.
  5. Inspect the cover-to-oil pan threaded bolt holes for damaged threads or debris.
  6. Inspect the crankshaft oil seal mounting bore for damage.
scientia non olet · About LEMON Manuals