LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1443 (Engine Mechanical - 4.2L (Ll8)) >> Repair Instructions >> On-Vehicle Repair Instructions >> Engine Mount and Bracket Replacement - Right >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Left Frame Engine Mount Bracket Bolts
    GM771633Courtesy of GENERAL MOTORS CORP.
  1. Graphic shows left, right is similar.

    Install the right frame engine mount bracket, if removed.

    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the right frame engine mount bracket bolts, if removed.

    Tighten:  Tighten the mount bracket bolts to 110 N.m (81 lb ft).

    3. Fig 2: View Of Left Engine Mount Bracket Bolts
    GM754318Courtesy of GENERAL MOTORS CORP.
  3. Graphic shows left, right is similar.

    Install the right engine mount bracket and secure with the bolts (1).

    Tighten:  Tighten the engine mount bracket bolts to 50 N.m (37 lb ft).

    4. Fig 3: View Of Upper Engine Mount Nuts
    GM754322Courtesy of GENERAL MOTORS CORP.
  4. Install the right engine mount.
    5. IMPORTANT: Ensure that the heat shield is located properly over the anti-rotation feature - right side only.
  5. Lower the engine onto the engine mounts.
  6. Install the right and the left upper engine mount nuts (1).

    Tighten:  Tighten the upper engine mount nuts to 70 N.m (52 lb ft).

  7. Raise the vehicle and remove the floor jack from under the vehicle.
  8. Install the engine protection shield and secure with the bolts. Refer to Engine Protection Shield Replacement in Frame and Underbody.
  9. Install the right and the left lower engine mount nuts.

    Tighten:  Tighten the lower engine mount nuts to 70 N.m (52 lb ft).

  10. Lower the vehicle.
  11. Install the right shock module. Refer to Shock Module Replacement in Front Suspension.
    12. Fig 4: View Of MAP Sensor & Retainer
    GM732839Courtesy of GENERAL MOTORS CORP.
  12. Install the MAP sensor (2).
  13. Install the MAP sensor retainer (1) and the electrical connector.
    14. Fig 5: Identifying Cooling Fan
    GM750177Courtesy of GENERAL MOTORS CORP.
  14. Connect the cooling fan hub nut to the water pump shaft.
  15. Using J 46406, install the fan clutch to the water pump pulley
  16. Connect the battery negative cable. Refer to Battery Negative Cable Disconnect/Connect Procedure in Engine Electrical.
scientia non olet · About LEMON Manuals