LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1443 (Engine Mechanical - 4.2L (Ll8)) >> Repair Instructions >> Off-Vehicle Repair Instructions >> Crankshaft Rear Oil Seal Installation >> Installation

Crankshaft Rear Oil Seal Installation: Installation

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Installing Crankshaft Rear Oil Seal
    GM654712Courtesy of GENERAL MOTORS CORP.
  1. Use the plastic installation sleeve supplied with the new seal when installing a new seal.

    Use J 44227  to install the crankshaft rear oil seal. See Special Tools and Equipment .

  2. Remove J 44227  . See Special Tools and Equipment .
scientia non olet · About LEMON Manuals