LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1443 (Engine Mechanical - 4.2L (Ll8)) >> Repair Instructions >> Off-Vehicle Repair Instructions >> Camshaft Position Actuator Valve Installation

Camshaft Position Actuator Valve Installation

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Camshaft Position Actuator Valve & Bolt
    GM637605Courtesy of GENERAL MOTORS CORP.
  1. Apply clean engine oil to the camshaft position actuator valve hole.
  2. Install the camshaft position actuator valve.
  3. Add sealant GM P/N United States 12346004, GM P/N Canada 10953480 to the camshaft position actuator valve bolt threads.
    4. NOTE: Refer to Fastener Notice in Cautions and Notices.
  4. Install the camshaft position actuator valve bolt.

    Tighten:  Tighten the camshaft position actuator valve bolt to 10 N.m (89 lb in).

scientia non olet · About LEMON Manuals