LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1443 (Engine Mechanical - 4.2L (Ll8)) >> Repair Instructions >> Off-Vehicle Repair Instructions >> Camshaft Cover Installation

Camshaft Cover Installation

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Camshaft Cover & Bolts
    GM637618Courtesy of GENERAL MOTORS CORP.
  1. Install a new camshaft cover seal.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the camshaft cover and bolts.

    Tighten:  Tighten the camshaft cover bolts to 10 N.m (89 lb in).

    3. Fig 2: View Of Ignition Control Modules & Bolts
    GM637619Courtesy of GENERAL MOTORS CORP.
  3. Install new ignition control module seals.
  4. Install the ignition control modules and bolts.

    Tighten:  Tighten the ignition control module bolts to 10 N.m (89 lb in).

scientia non olet · About LEMON Manuals