LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1440 (Tires & Wheels) >> Repair Instructions >> Tire Hoist and Shaft Replacement >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Removing/Installing Spare Wheel Hoist Assembly
    GM749244Courtesy of GENERAL MOTORS CORP.
  1. Install the spare wheel hoist assembly to the vehicle.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install spare wheel hoist assembly mounting bolts to the frame

    Tighten:  Tighten the spare wheel hoist assembly mounting bolts to the frame to 50 N.m (37 lb in).

  3. Install the spare tire to the spare tire carrier.
  4. Lower the vehicle.
scientia non olet · About LEMON Manuals