LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1439 (Bumper System) >> Repair Instructions >> Step Pad Replacement - Rear Bumper (TrailBlazer) >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the backing from the adhesive strips.
  2. Position the step pad to the fascia.
  3. Install the step pad to the fascia, ensuring that the retaining tabs are thoroughly engaged, and the end of the step pad are secured.
    4. NOTE: Refer to Fastener Notice in Cautions and Notices.
  4. Install the bolts.

    Tighten:  Tighten the step pad retaining bolts to 10 N.m (89 lb in).

scientia non olet · About LEMON Manuals