LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1439 (Bumper System) >> Repair Instructions >> Impact Bar Replacement - Rear Bumper >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the spare tire carrier. Refer to Tire Hoist and Shaft Replacement in Tires and Wheels.
  2. Remove the rear fascia. Refer to Fascia Replacement - Rear Bumper .
  3. Disconnect the trailer/towing receptacle electrical connector.
    Fig 1: Disconnecting Trailer/Towing Receptacle Electrical Connector
    GM752485Courtesy of GENERAL MOTORS CORP.
  4. Rotate the trailer/towing receptacle assembly counterclockwise and remove from the vehicle.
    5. Fig 2: Removing Rear Impact Bar Assembly-To-Frame Rail Bolts
    GM752281Courtesy of GENERAL MOTORS CORP.
  5. Remove the 4 rearward bolts that retain the impact bar assembly to the frame rails.
  6. While an assistant holds the impact bar (1) assembly in place, remove the remaining 2 retaining bolts.
  7. Remove the impact bar (1) assembly from the vehicle with an assistant.
scientia non olet · About LEMON Manuals