LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1439 (Bumper System) >> Repair Instructions >> Impact Bar Replacement - Rear Bumper >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the impact bar (1) assembly to the vehicle with an assistant.
    Fig 1: Installing Rear Impact Bar Assembly-To-Frame Rail Bolts
    GM752281Courtesy of GENERAL MOTORS CORP.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the bolts that retain the rear impact bar to the frame.

    Tighten:  Tighten the rear impact bar bolts to 364 N.m (268 lb ft).

  3. Install the trailer/towing receptacle assembly to the bracket and rotate clockwise until fully seated.
  4. Connect the trailer/towing receptacle electrical connector.
    Fig 2: Connecting Trailer/Towing Receptacle Electrical Connector
    GM752485Courtesy of GENERAL MOTORS CORP.
  5. Install the rear fascia. Refer to Fascia Replacement - Rear Bumper .
  6. Install the spare tire carrier. Refer to Tire Hoist and Shaft Replacement in Tires and Wheels.
scientia non olet · About LEMON Manuals