Installation Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.

Install the tow hooks to the impact bar. Refer to Tow Hook Replacement - Front (Chevrolet (X88) ONLY) in Frame and Underbody.
Position the impact bar (3) to the frame (2).

Fig 1: Installing Impact Bar-To-Frame Bolts
Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the bolts (1) that retain the impact bar to the frame.
Tighten: Tighten the bolts to 85 N.m (63 lb ft).
Position the fascia support rods (2) to the impact bar (5).

Fig 2: View Of Fascia-To-Fascia Support Rod Push-Pins
Courtesy of GENERAL MOTORS CORP.
Install the bolts (2) which retain the fascia support rods to the impact bar.
Tighten: Tighten the bolts to 10 N.m (89 lb in).
Install the front fascia. Refer to Fascia Replacement - Front Bumper (Rainier) , Fascia Replacement - Front Bumper (Bravada) , Fascia Replacement - Front Bumper (Envoy, Envoy XUV) or Fascia Replacement - Front Bumper (TrailBlazer) .