LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1439 (Bumper System) >> Repair Instructions >> Fascia Replacement - Rear Bumper >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the backup lamp socket assemblies from the backup lamp housings, if applicable. Refer to Backup Lamp Replacement (GMC) in Lighting Systems.
  2. Remove the lower fascia push-pins.
    Fig 1: Removing Lower Rear Fascia Push-Pins
    GM743497Courtesy of GENERAL MOTORS CORP.
  3. Remove the screws from the rear wheelhouse flanges.
    Fig 2: Removing Rear Wheelhouse Flange Screws
    GM743499Courtesy of GENERAL MOTORS CORP.
  4. Remove the upper retaining bolts from the back of the fascia.
    Fig 3: Removing Upper Retaining Bolts From Back Of Rear Fascia
    GM743498Courtesy of GENERAL MOTORS CORP.
  5. Remove the fascia from the vehicle.